So I'm shaping a 9'6 60ish pig and have my rocker and middle thickness right where I want it. I was looking to go for a flat deck line on this board, and was running into a foam distribution problem.
I started off with a 10'3 blank, flipped the temple on the blank and pulled it back to move the apex towards the wide point. At this point my rocker apex is -9 and my wide point is -11.
I cut off all of what was originally the tail of the blank, which moved my apex back, but now I have too much foam in the back of the board.
Current thicknesses:
1 10/16 @ 12 from nose
3 1/4 @ middle
2 5/16 @ 12 from tail
My problem is if I thinned the nose and tail from the bottom the rocker would change, and if I took it from the top I am unable to get the flat deck I was looking to get.
Am I missing something or do I just need to foil the nose and tail from the top?
If I want to keep my middle thickness where it is, but have nose and tail at something around 1", am I going to have to foil out the deck from the middle towards each end?