Hi, I bought futures one pass installation kit from Foamez a while back but never used it till yesterday. Watched the video, read the attached manual and was about to route the center fin. I realised that the router slide was too tight on the jig plate and wouldn't slide without jerking. It damaged the foam a bit because of the jerk. I picked up the jig plate off the foam and tried to slide the router slide back and forth but it was very tight. I just thought it might be because it is new, so i slide the router slide on the jig plate back and forth maybe a hundred times hitting all circumfurance of the plastic side. After that i could see some improvement but still some tightness to it. Is this a common problem with the new futures one pass installation kit?
Forums: