Hey guys! I have not been posting much in a while due to some other projects taking up lots of my time, but still been building plenty of boards....
So I just glassed a board with Poly glass job, hot coat and sand. Realized I was way too short on remaining resin to do a gloss coat, so off to Home depot I went. Wiped on two very nice coats of Behr Low luster and the board is now dry. Getting ready to do the maroon and grey scothbrite pads and went to read a little about it... Basically wondered if by hand or machine.
In reading, it occured to me everyone is referencing the Behr sealer on Epoxy boards... Anyone ever put the sealer on poly boards? Did I screw up? Will this be fine? I could not imagine that it will have too much of a negative effect as it is too thin to really peel off like an unbonded gloss coat can do, but just need peace of mind. So how bad did I screw up, or is this standard practice?
Thanks in advance