Hello all, firstly thanks for all your hard earned and generously shared knowledge...
I have just done a nose patch fabric inlay on a 9'0. I glassed the base and did a cutlap to meet the edge of the fabric where the pinline will be. All went well.
My question is - Would you do deck patch inlay of glass to meet the fabric, then one layer over the whole deck ( glass is 6oz ) or can i just do two layers as normal? I pressed the edges of the inlay down when " leather hard " so it would be nice and flat.. The board is clear ( no pig or tint ) but im not fond of freelapping, I like cut laps.
So, would i just sand my lapline and glass deck as normal or do a glass inlay? or is this just personal preference??
Any and all advice is greatly appreciated, thanks ..