I ran into some issues after I started sanding my hot coat. I posted previously regarding air bubbles along the rail after lam. I cut them out with razor and repatched and that worked out great. But a few other spots I had bubble, the patch popped out during sanding. I believe I was sanding too hard. I did not use enough catalyst so my hot coat turned out gummy so I was trying to get through the gum. See pictures below:
My thought would be to either patch with glass and resin and re-hot coat. Or to just fill holes with resin, then hot coat again. How should I go about this?
Also, I have some yellowish/brown spots after sanding. I think this could be gummed up hot coat from sanding too intense. ANy ideas on how to fix this?
Always appreciate your help,
AFry
