Hi all,
I'm new here but have been using this resource for a bit (super helpful)! I'm about to build a chambered paulownia board that I really would rather not use glass or resin on.
i'm happy with most of the process but i'm not sure what adhesive and sealant to use when installing my fin plugs (just adhesive as the hole wont go through to the chamber) and more specifically a vent plug (what one do you recommend)? When installing the vent plug i'll use epoxy putty i assume as that seems to be the norm but if i'm only oiling (or something similar) the board then how will i create a proper seal around the vent plug without using epoxy?
I hope this makes sense and that someone might have a tip or two for me.
While i'm here does anyone have any suggestions for wood glue to use (Titebond 3?) or any other tips for anything chambered board related?
Thanks so much,
Joe