aloha all, Im on my 4th board and this will be my 2nd time installing futures boxes. I use epoxy resin, and I've just installed some gearbox boxes in a board pre-glass, but won't be laminating until i set up my backyard tent for glassing. So before i put these futures boxes in this next board- Is the process for a pre-glass finbox install normally done right before lamming the board? I tape around my routes so the epoxy doesnt spread further out than necessary, but there always seems to be some cured resin in some spots either built up on the flanges and/or some that seeped under my tape job around the routes etc. If i've allowed the resin to cure before laminating it, what's the best way to scuff this resin up that has cured on the flanges/box covers of the gearbox without damaging the surrounding foam? tape?
Here's the board. know theres some gemini proponents in the crowd here.. it's pretty much a symmetrical version of Ryan Burch's twinfin gemini picklefork thingy. dont mind my fin marks either..im a total backyard hack pretty much.
