Hey Swaylocks, I'm just about finished with my first board and this forum has been a huge help throughout. I installed FCS 2-tab plugs the other night in my new big boy thruster, and realized the next day that at least one of the "center" plugs is attached to a side fin, and vice versa there's a rail fin plug in the center. Can't tell through the resin yet where the others ended up. I think I have a pretty good idea of how I would go about getting them out and re-doing the install properly with a hole saw and forstner bit, but was really hoping to take it on a test run Friday morning. Is there any reason not to just ride this thing for a bit with the center and side fin plugs mixed up? Will it noticeably affect performance? Thanks in advance.
Forums: