Hi There. New to the forum and I tried searching but was unable to find an answer to my question....hoping someone might be able to chime in.
I am on my second board. (First one did opaque resin since it was easier) I did a clear bottom lamination (PU blank with polyester resin) with a freelap. The lamination turned out much better this time, but I had cut the laps a bit long. After I flipped the board, I noticed I needed a slight basting to touch up a couple spots that weren't fully saturated. I am going to do a fabric 3/4 inlay, and was planning on using clear lamination for the top.
Questions: Will my freelap and baste show through a clear lamination on the top? If so, would it best to do a cutlap top deck lamination with tint to hide the freelap and baste areas? I will try to log in on my phone and upload a picture as I keep getting an error when trying from my laptop.
Thanks in advance for helping this noob!