Forums:
Hi There, I'm a new board builder. After hours of research, planning and gathering materials I'm finally rolling. I built my first EPS blank, cut the outline, squared the rails and foiled the rocker and I'm ready to start the serious shaping. I drew up a couple designes in Shape3dX Lite and I'm having a hard time figuring out how to take the designs from the software to the blank. I would like to be able to mark railband guide points and draw railbands on the board (as described in Greenlight's building guide), but I'm not sure how to get those measurements from the Shape3d software. If anyone has more experiance with Shape3d and can help me figure this out, I would greatly appreciate it.
Thanks, Andrew