Forums:
Hi, I was trying to install FCS X2 fin plugs and I mixed 2:1 Epoxy with some chopped fibreglass. The solution became too thick to pour into the "H" hole (recommended by FCS) I drilled out. I poured it in anyway, using a stick I pushed the mix into the pockets that was drilled all the way to just below the deck fiberglass. My Epoxy mix hardened so fast that I did not have time to fit the fin plugs in. When I drilled out the hardened epoxy again to salvage the board, I realised that the EPS foam was burnt by the overheating of the Epoxy. My question is, how do you limit the heat to stop Epoxy from burning the foam? Thank you